Need Help Identifying A Jig

Discussion in 'Jigging and Popping' started by BillyFun, Jan 7, 2017.

  1. BillyFun

    BillyFun Newbie

    Location:
    Santa Barbara, Ca.
    Name:
    Bill Dunn
    Boat:
    N/A
    • Messages:
      (443)
    • Likes Received:
      (21)
    I would like to id the middle jig. It is a lightweight jig and I think it was made by Salas. The one on the left is a PL68 and the one on the right is a 6X Jr.

    Any help would be appreciated. Thanks.

    IMG_2571.JPG
     
  2. BillyFun

    BillyFun Newbie

    Location:
    Santa Barbara, Ca.
    Name:
    Bill Dunn
    Boat:
    N/A
    • Messages:
      (443)
    • Likes Received:
      (21)

    There are no markings on the front or back.
     
  3. gved823

    gved823 Member

    Location:
    Lakewood
    Name:
    Gary
    Boat:
    Sold
    • Messages:
      (479)
    • Likes Received:
      (230)
    Salas PDQ?
     
  4. BillyFun

    BillyFun Newbie

    Location:
    Santa Barbara, Ca.
    Name:
    Bill Dunn
    Boat:
    N/A
    • Messages:
      (443)
    • Likes Received:
      (21)
    Actually, Eric, from Eric's Tackle identified it as a Salas TNT. Thanks for your response.
     
  5. BillyFun

    BillyFun Newbie

    Location:
    Santa Barbara, Ca.
    Name:
    Bill Dunn
    Boat:
    N/A
    • Messages:
      (443)
    • Likes Received:
      (21)

    Thanks everyone. Eric, from Eric's Tackle was able to Id the white jig (actually before I even put it on the counter). Since then, I've been able to find a couple. Thanks again.

    IMG_2624.JPG IMG_2624.JPG
     

Share This Page