How to replace talica ii handle?

Discussion in 'Shimano Fishing Gear' started by flyhigh123, May 9, 2018.

  1. flyhigh123

    flyhigh123 Bangarang

    Location:
    los angeles
    Name:
    flyhigh123
    Boat:
    Parker 2320
    • Messages:
      (1,314)
    • Likes Received:
      (487)
    I have a talica 20, bought a handle upgrade. Is there a way to replace just the knob handle portion and not the arm?
     
  2. Bantam1

    Bantam1 Shimano Rep Advertiser

    Location:
    Irvine, CA
    Name:
    Dan
    Boat:
    N/A
    • Messages:
      (2,129)
    • Likes Received:
      (719)
    There is no way to install the knob from the TAC50 onto the handle for a 20 for example.

    The handle installation is pretty simple. There are two screws holding the cover for the push button shield on. The lever slides off then the handle nut retainer will come off. You can use an adjustable wrench to remove the handle nut. Reverse the procedure for installation. It should take about 2 minutes if you have basic mechanical skills.
     
    flyhigh123 likes this.
  3. Fishingguy

    Fishingguy I've posted enough I should edit this section

    Location:
    Orange County
    Name:
    Billy
    Boat:
    Parker
    • Messages:
      (1,186)
    • Likes Received:
      (1,637)
    Do we need parts for conversion? or simply just the handle assembly TGT1936?


    TGT1934 HANDLE BOLT PLATE
    TGT1933 PUSH BUTTON SHIELD
    TGT0767(2) LEFT SIDE PLATE SCREW


     
  4. Bantam1

    Bantam1 Shimano Rep Advertiser

    Location:
    Irvine, CA
    Name:
    Dan
    Boat:
    N/A
    • Messages:
      (2,129)
    • Likes Received:
      (719)
    You will need the plate, shield and two screws. In a pinch you can drill out the holes in the plates to use the slightly larger screws. It's easier just to obtain all the parts and do the swap. Total cost is about $95.
     

Share This Page