Good Price on DR balls..

Discussion in 'Pacific North West Classifieds' started by LJB, Feb 5, 2019.

  1. TooManyHobbies

    TooManyHobbies The guy that makes the glass stuff

    Location:
    White trashville
    Name:
    Garrett
    Boat:
    21' SeaRay Laguna CC "Sea 'Scape"
    • Messages:
      (1,605)
    • Likes Received:
      (995)
    I made one out of channel iron. Welded plate on the ends and then laid two beads of weld inside the channel for a zip-tie/wire to catch on. My calc. was a bit off though; they are only 9 lbs...
     
    EJ Swanny likes this.
  2. EJ Swanny

    EJ Swanny I've posted enough I should edit this section

    Location:
    Redondo/WA
    Name:
    Erik
    Boat:
    "Riley-J" 2006 21' Proline Tourney
    • Messages:
      (2,488)
    • Likes Received:
      (1,217)
    Not a bad idea....hell, I was thinking about just buying some clay, make a 1"X2"X12" channel, and doing a straight pour, drill a couple holes, and weights for crab/shrimp. Zip tie as many or as few as needed....better than a brick, and fit nicely in the sides...
     
  3. LJB

    LJB Down Fur-Lined Avenue

    Location:
    Tacoma
    Name:
    ain't no cunthead
    Boat:
    68 Bellboy
    • Messages:
      (1,427)
    • Likes Received:
      (617)
    Just zip tying without holes would be fine,, Or drill a a couple holes in the mold insert bolt and use a punch to knock it back out..

    Where are these crabs :)
     
    EJ Swanny likes this.
  4. EJ Swanny

    EJ Swanny I've posted enough I should edit this section

    Location:
    Redondo/WA
    Name:
    Erik
    Boat:
    "Riley-J" 2006 21' Proline Tourney
    • Messages:
      (2,488)
    • Likes Received:
      (1,217)
    Same place the shrimp are....hmmmm, I'll just say I'm going way North...some can go south, and some west. We all know not here...unless you want some barnacle covered, lead poisoned Reds, which at this point, sound tasty..
     
  5. LJB

    LJB Down Fur-Lined Avenue

    Location:
    Tacoma
    Name:
    ain't no cunthead
    Boat:
    68 Bellboy
    • Messages:
      (1,427)
    • Likes Received:
      (617)
    I mentioned the bolt idea because Ive drilled lead and its a bit tricky..
     
    EJ Swanny likes this.
  6. jet2go

    jet2go Member

    Location:
    Issaquah, WA, USA
    Name:
    Gary
    Boat:
    26' Silver Streak, Twin 200 Suzukis, 9.9 yami, "Outta Line"
    • Messages:
      (321)
    • Likes Received:
      (51)
    But who has a good deal on 20lbers? Just set up my new Scottys and need bigger balls!
     

Share This Page