1973 Chevy c10 longbed project. Have had the truck for about 2 years. I’ve got it to the point where it needs the front clip put back on and wiring hooked back up plus some other little odds and ends. I wanted to make this a cruiser/daily driver but work is too busy and I have no time to work on truck anymore. Here’s some details about the truck. -SBC 327 motor -Turbo 350 trans -Clean interior -New custom built drive shaft. -New inner fender wells -New upper and lower ball joints -New idler arm -New 3inch drop spindles (have original spindles too) -Rear flip kit installed by SoCal suspension in El Cajon - I have a new spare universal working harness if needed - I have some of the badges I even have the original build sheet. I hate to see it go but someone needs to get her back on the road. Asking $2500 o.b.o NOW $2300 All offers will be considered. Worst I can say is no.