<section id="postingbody"> Please read the add before sending me a PM. $ 75.00
Oldie but goodie, Right hand tilt, miter gauge, new drive belt with a new spare. comes with 3 inserts. No dado insert. comes with parts and owners booklet and blade removal tool but no blades.. I need the room wife just purchased a new jet saw for me and I need the room.
On the left side of the saw at the base is two casters that make it much easier to move the saw around the work shop, you just grab rails on the right and lift and you can roll it around. It might have a bearing going out because the blade just started to wobble a bit, bearing is replaceable, This will need to be addressed. Fence in good shape with normal wear. The plastic gauge for the measuring device is missing, I never liked it any way. I just use a tape measure between the fence and the blade because the accuracy it better . This is not belt driven, but direct drive. There is a belt on the motor itself for gearing the blade only. No low ballers. I will not respond to and e-mails with out a phone number or you will be deleted. Yes it runs! motor is 1 1/3 hp and is 110 volts not 220.
Ray</section>
Oldie but goodie, Right hand tilt, miter gauge, new drive belt with a new spare. comes with 3 inserts. No dado insert. comes with parts and owners booklet and blade removal tool but no blades.. I need the room wife just purchased a new jet saw for me and I need the room.
On the left side of the saw at the base is two casters that make it much easier to move the saw around the work shop, you just grab rails on the right and lift and you can roll it around. It might have a bearing going out because the blade just started to wobble a bit, bearing is replaceable, This will need to be addressed. Fence in good shape with normal wear. The plastic gauge for the measuring device is missing, I never liked it any way. I just use a tape measure between the fence and the blade because the accuracy it better . This is not belt driven, but direct drive. There is a belt on the motor itself for gearing the blade only. No low ballers. I will not respond to and e-mails with out a phone number or you will be deleted. Yes it runs! motor is 1 1/3 hp and is 110 volts not 220.
Ray</section>
Attachments
Upvote
0
