If you read this thread
www.bdoutdoors.com
You will see I am replacing all my running gear so the old stuff Im taking off some of it I am sure is still usable.
6 idler hubs (rusty but serviceable)
4 12" rotors (can probably be turned on a lathe)
4 calipers not sure if rebuildable
4 backing plate ( since my new stuff should have new plates)
would make great back up or if you low on funds for new brakes Im sure you can make some of it work.
I would but Im just not that guy and rather have all new
All removed before any catastrophic failures.
HMU if you want this stuff located in San Diego 92123
Not available till I get my new stuff later this week.
Don't forget to pull your bearing buddies and check stuff...
Bumping to top to see if anyone wants the older stuff before I have it picked up by the scrap guy. Hubs actually clean up nice as I took one to my bench wire wheel and die grinder. 25880 inner bearings and 15123 are the outer I believe...
www.bdoutdoors.com
You will see I am replacing all my running gear so the old stuff Im taking off some of it I am sure is still usable.
6 idler hubs (rusty but serviceable)
4 12" rotors (can probably be turned on a lathe)
4 calipers not sure if rebuildable
4 backing plate ( since my new stuff should have new plates)
would make great back up or if you low on funds for new brakes Im sure you can make some of it work.
I would but Im just not that guy and rather have all new
All removed before any catastrophic failures.
HMU if you want this stuff located in San Diego 92123
Not available till I get my new stuff later this week.
