Shimano tld25

Discussion in 'Fishing Reels' started by tlynch, Jul 19, 2007.

  1. tlynch

    tlynch Newbie

    Location:
    san diego/bullhead city
    Name:
    Aquaman
    Boat:
    28' grady
    • Messages:
      (31)
    • Likes Received:
      (0)
    I have a shimano tld25 that when I put it in gear it is hard to crank, I looked inside and cleaned and lubed but it still does it. Is the drag washer supposed to be lubed?Any advice would be appreciated.
     
  2. reelbadlarry

    reelbadlarry Member

    Location:
    socal
    Name:
    Larry
    Boat:
    23ft parker, reel bad
    • Messages:
      (425)
    • Likes Received:
      (37)
    the canvas washer, no. Get a carbontex drag for it. Look in the reel tutoriols and follow the directions for the tld15.
     
  3. Addicted2fishin

    Addicted2fishin where's da fish

    Location:
    Hawaii
    Name:
    RJ
    Boat:
    19 Glasspro, 17 Ali'i Kai
    • Messages:
      (831)
    • Likes Received:
      (2)
    most likely the bearings. Pull and check. If not then disassemble and reassemble according to schematics.
     
  4. alantani

    alantani Well-Known "Member"

    Location:
    Saratoga, CA
    Name:
    alan tani
    Boat:
    grady white tournament 19, grady white journey 258
    • Messages:
      (1,764)
    • Likes Received:
      (222)
    right main side plate bearing......
     
  5. tlynch

    tlynch Newbie

    Location:
    san diego/bullhead city
    Name:
    Aquaman
    Boat:
    28' grady
    • Messages:
      (31)
    • Likes Received:
      (0)
    Its fixed, thanks for the help
     

Share This Page